- หน้าแรก
- สินค้าและบริการ
- เครื่องฉีดพลาสติก/ไส้กรองน้ำมัน
- Phoenix series
(Swing arm robots)
Phoenix series
(Swing arm robots)
(Swing arm robots)
The Phoenix series offers take -times available for sprue separation and parts removal. Self-lubricating Pneumatic drive system affords low maintenance, exceptional stability and reliability. This series of robots are constructed on modular principle to ensure high precision and lightness. The main arm rides vertically on a linear slide-rail and slides horizontally (crosswise) on two roller guide-ways, no maintenance is required and smooth running and the elimination of play/slack is ensured. Travel cushions on the vertical axis minimize vibration and ensure smooth deceleration; hydraulic shock absorbers are fitted on the crosswise axis for efficient damping.
For maximum flexibility the arm can be easily adjusted to release runner/parts at the operator or the rear side of the machine.
Swing angle can be freely adjusted between 60 to 90 degree through a positive but easily adjusted location fitting on the cylinder-driven oscillating arm.
The manual clamp system on the Phoenix series of robots allowed them to swing clear of the mould area in seconds; without the use of tools. Built-in ratchet mechanism, which controls motion of the robot arm out of the mould area, enables easy mould changes or maintenance.
ไส้กรอง RRR ผลิตจากประเทศญี่ปุ่น สามารถดูดซับความชื้นที่เกิดจากการเปลี่ยนแปลงอุณหภูมิของน้ำมันหล่อลื่น และกรองสารปนเปื้อนเล็กที่สุดได้ถึง 0.1 ไมครอน
Redstone series is applicable to all types of horizontal injection machine from 50 to 500 tons. Full AC servo motor driven on each axis, take-out at super high-speed(0.48sec.) and dry cycle time Within 4.8 seconds. It constantly positions the robot arm and end-of-arm tooling to degrees of accuracy within +∮0.15mm. Program can be taught. The motion can be set according different requirement, with high-efficiency take-out function. Applicable to take-out products with short forming cycle or complex automatic. It has ranges of model R600/R700/R800/R900/R1000/R11000, with two types of arms, single stage and telescopic type; Vertical Stroke: 600~1100mm. It can be added with sub arm for three-plate mold. To take-out at high-speed increases output greatly. Feature - Driven by high performance AC servo motor, it can take-out variety depth products. To take-out at super high-speed, greatly increased output efficiency. - High rigidity 3D structure design, stable construction, low vibration, longwearing and long-life. - Using special high precision and high speed linear slide rail, wearproof, heatproof, long-life and not deformed. - Arm with high rigidity aluminum beam, light mass, high rigidity, cooperated with double-speed belt construction ensured the take-out time. - T type steel wire PU belt driven, good stability, precision position at ∮0.15mm.